Getting the signal to the input, at the frequencies you can measure, it is feasible using jumper wires. Horizontal and Vertical Cursors with automatic waveform measurements, and waveform references. For low cost concept teaching it will be adequate and you might not need scope probes as it plugs into a bread board from which gets the power.Channel Math: add, multiply, invert, and average.The Xprotolab and Xminilab can be plugged directly on a breadboard. The XScopes can also be used as development boards for the AVR XMEGA microcontroller.
#Xscope xprotolab plain generator
Spectrum Analyzer with different windowing options and selectable vertical log and IQ visualization. The XScopes are a combination of three electronic instruments: a mixed signal oscilloscope, an arbitrary waveform generator and a protocol sniffer.XY Mode: For plotting Lissajous figures, V/I curves or checking the phase difference between two waveforms.Meter Mode: VDC, VPP and Frequency readout.Advanced Triggering System: Normal / Single / Auto / Free, with many trigger modes adjustable trigger level, and ability to view signals prior to the trigger.Arbitrary Waveform Generator with advanced sweep options on all the wave parameters.Mixed Signal Oscilloscope: Simultaneous sampling of 2 analog and 8 digital signals.If I fry mine I'll definitely get another. (I could measure up to about 500kHz from another source). a jumper wire) into the signal generator output and see the waveforms up to 100kHz. The XScopes can also be used as development boards for the AVR XMEGA microcontroller. The application has tabs for the oscilloscope, voltmeter, signal generator and logic functions. The XScopes are a combination of three electronic instruments: a mixed signal oscilloscope, an arbitrary waveform generator and a protocol sniffer.
0 kommentar(er)
